joanna yan
Senior Member
Bean peeling machine common faults:
1. The material stays unilateral. This may be caused by the following factors:
a. The material in the feeding port doesn’t drop in the middle of the feeding tank.
b. Uneven baiting along with the direction of the baiting hopper width.
c. The screen body has uneven horizontal plane.
For these bean peeling machine faults, we can do the following things:
a. Adjust the feeding taper pipe and make the material drop in the middle of the feeding tank.
b. We can adjust the feeding tank and control bypass flow condition of the material.
c. Check whether the rack installation is flat and the rubber springs are the same high.
2. The screen body has phenomenon of pendulum. This may be due to the four uneven supporting points, cavity rubber mattress damage, different phase angles of the motor fan-shaped block, different installation angles of the motors of the two sides and the still motor of one side.
3. Bean peeling machinehas low impurities removing efficiency and yield. This is usually caused by the improper amplitude size, vibration angle and sifter dip angle, blocked sieve mesh and too low position of feeding choke plate.
see more information on www.grain-peeling-machine.com
contact me through joannayan198712@gmail.com
1. The material stays unilateral. This may be caused by the following factors:
a. The material in the feeding port doesn’t drop in the middle of the feeding tank.
b. Uneven baiting along with the direction of the baiting hopper width.
c. The screen body has uneven horizontal plane.
For these bean peeling machine faults, we can do the following things:
a. Adjust the feeding taper pipe and make the material drop in the middle of the feeding tank.
b. We can adjust the feeding tank and control bypass flow condition of the material.
c. Check whether the rack installation is flat and the rubber springs are the same high.
2. The screen body has phenomenon of pendulum. This may be due to the four uneven supporting points, cavity rubber mattress damage, different phase angles of the motor fan-shaped block, different installation angles of the motors of the two sides and the still motor of one side.
3. Bean peeling machinehas low impurities removing efficiency and yield. This is usually caused by the improper amplitude size, vibration angle and sifter dip angle, blocked sieve mesh and too low position of feeding choke plate.
see more information on www.grain-peeling-machine.com
contact me through joannayan198712@gmail.com