Vertical roller mill production process occurs in the normal vibration phenomenon is normal, but normal vibrations are within a fixed range of vibrations, if there is some special cases, it will lead to abnormal vibration mill vertical phenomenon. Cause abnormal vibration mill vertical have uneven thickness the material layer, which is the main, but also probably because too much bulk material, the material pressure roller mill is too large, the vertical roller mill and disc, etc. wear parts wear large, inadequate ventilation and other reasons. Faced with these phenomena, you need to take some measures to control the vibration of the mill vertical, like the control feed size, feed rate control, timely replacement of wear parts, lm vertical roller grinding mills to adjust the distance between the rollers grinding disc and etc. in order to reduce the vertical vibration mill is not working properly arise.
To vertical roller mill is operating normally at work, you need to pay attention to the thickness of the machine grinding chamber material layer, the material layer is stable, then the air volume within the system to stabilize pressure and volume of feed. Adjust vertical roller mill material thickness of methods to adjust the air volume, can be achieved by adjusting the feed rate. Vertical roller mill depends on the thickness of the material layer material moisture content, particle size, particle distribution is easy to wear and so on, when the user for information after a thorough understanding of the material may be freely control the thickness of the material, in order to control Li normal operation of the vertical roller mill machine .
SBM LM series vertical mill is easy to operate control
Vertical mill operation when an indicator of operating pressure is also important to note the user, the system pressure refers to the pressure loss at the air ring sizes. Vertical mill system is running smoothly by the wind, the wind flow on the formation pressure within the system, and the wind can drive the flow of material flow, ensure the smooth operation of the system. Size and size of the wind system pressure and feed rate of about, when the pressure is too large the system can be judged in the resistance is too large, this resistance may be caused due to excessive material, it may be because the system caused by poor circulation. Vertical mill to reduce the pressure of methods to increase the ventilation rate, increase the amount of water, a stable material layer, reducing the classifier speed. Pressure is too small, the opposite to the above reasons, the user can operate the reverse, but the pressure is too small or water should be increased, so that the material layer is stable.
To vertical roller mill is operating normally at work, you need to pay attention to the thickness of the machine grinding chamber material layer, the material layer is stable, then the air volume within the system to stabilize pressure and volume of feed. Adjust vertical roller mill material thickness of methods to adjust the air volume, can be achieved by adjusting the feed rate. Vertical roller mill depends on the thickness of the material layer material moisture content, particle size, particle distribution is easy to wear and so on, when the user for information after a thorough understanding of the material may be freely control the thickness of the material, in order to control Li normal operation of the vertical roller mill machine .
SBM LM series vertical mill is easy to operate control
Vertical mill operation when an indicator of operating pressure is also important to note the user, the system pressure refers to the pressure loss at the air ring sizes. Vertical mill system is running smoothly by the wind, the wind flow on the formation pressure within the system, and the wind can drive the flow of material flow, ensure the smooth operation of the system. Size and size of the wind system pressure and feed rate of about, when the pressure is too large the system can be judged in the resistance is too large, this resistance may be caused due to excessive material, it may be because the system caused by poor circulation. Vertical mill to reduce the pressure of methods to increase the ventilation rate, increase the amount of water, a stable material layer, reducing the classifier speed. Pressure is too small, the opposite to the above reasons, the user can operate the reverse, but the pressure is too small or water should be increased, so that the material layer is stable.