APSA-80 “Best For Indian Agriculture”
Indian farmers are facing many problems. Some of them are listed below:
Less Water
Increasing amount of seeds
Increasing amount of fertilisers
Not getting full results from pesticides
All these problems can be solved by using APSA-80.
APSA-80 is an “All Purpose Spray Adjuvant” which on mixing with insecticides, fungicides, herbicides and defoliators increase their efficacy. As a result of that, the corps, fruits and vegetables are better protected from diseases, pests and unwanted herbs, resulting in more productive yield. This adjuvant is 80 % of active ingredients and can be mixed with in any solution to improve its performance many times.
APSA-80 is neither an insecticide nor a fertiliser. It is an adjuvant that enhance the performance of the insecticides and fertilisers and also helps the water or solution to penetrate deeper.
How Does APSA-80 Works?
It contains specials element “Non Ironic Surfactants” that beaks the surface tension of the water. These surfactants work on the surface of water droplet to reduce its tendency to bead up pulling the water and wax on the leaf surface together, reducing the water’s surface tension and causing the water droplet spread out. When the water used in pesticide sprays spreads out more evenly, the result is much better pesticide coverage. Adding APSA-80 helps insecticides, defoliators and foliar fertilisers to penetrate the surface of the leaf faster and more evenly.
How to use APSA-80?
With Insecticides, Fungicides, Foliar Fertilisers and Defoliators
Prepare a solution of insecticide/fungicide/foliar fertiliser/defoliator with water. Follow the mixing instructions recommended by the manufacturer.
Mix 5 ML of APSA-80 (1/4 capful) per 15 lit of pesticide/foliar solution.
Spray normally on the crop.
With Post-Emergent Herbicides:
Make a solution of herbicide to be used with water in the spray tank. Follow the mixing instruction recommended by the herbicides manufacturer.
Mix 20 Ml of APSA-80 (1 capful) per 15 lit of herbicides solution.
Spray normally on the crop.
For Use as an Irrigation Aid or Golf Courses:
Mix 160 Ml of APSA-80 (8 capfuls) in at least 80 lit of water per acre. The dosage of ASPA-80 will remain 160 ml per acre of land even if the water required is more than 80 lit to cover an acre of land.
About 12 hours before irrigating, spray this mixture of ASPA-80 and water directly on the entire land area which is to be irrigated. Spray directly on the soil.
Let the water flow into the land see how it penetrate the soil better and also spreads better.
The above mentioned spray of the APSA-80 will remain effective about 4 weeks. Repeat the above steps for irrigation after a month.
Advantages of APSA-80
Offers farmers an excellent opportunity to increase their crop yields.
Spreaders: provides more uniform spray deposit on plants; improves coverage of insecticides, herbicides; fungicides and foliar fertiliser sprays.
Activator: thorough wetting action helps improve performance of post-emergent insecticides and fungicides.
For use of growing and harvested crops.
Helps in dispersing powders and oil-base liquids.
The International and Indian test results on verity of crops proves the effectiveness of APSA-80 for improving pesticide coverage and performance.
Increases water penetration- gets more water into the soil. Also aids irrigation by reducing run-off; saves water.
Aids irrigation by increasing rate at which water soaks into soil; promotes more efficient water usages.
Helps keep spray equipment clean and prevent closed nozzles-reduces down time.
Non-corrosive to equipment.
Biodegradable.
According to Indian researches, APSA-80 fetches a return of 12 to 58 times of the amount spent on it.
APSA-80 – USDA approved surfactant / adjuvant – when used as spray adjuvant with herbicides and pesticides
Allows a more uniform spray improving coverage.
Breaks down surface tension of water allowing better penetration of leaves.
Reduces corrosion and clogging of spray nozzles.
Significantly increases percent and time of effectiveness.
APSA-80 – USDA approved surfactant / adjuvant – when used as soil conditioner
Reduces compaction allowing deeper roots and better takeup of water and nutrients.
Faster water infiltration rates, less runoff and better water holding capacity.
Maintains more nitrogen in the upper profile of the soil.
Increased yields **
Nutriplant SD / SL Seed Treatment – unique blend of micronutrients complexed with fermintation metabolites
Better root development.
Faster emergence.
Increased resistance to environment stress.
Increased yields**
Nutriplant AG – a foliar-applied, liquid, micronutrient supplemental fertilizer
Designed to give the plant what it needs at critical growth stages.
Stimulates plant metabolizm.
Increased resistance to stress.
Increased yields**
for more information
contact
