joanna yan
Senior Member
When we operate the MAIZE MILLING MACHINE, we will come across some malfunctions. Today I introduce some common malfunctions the solutions. Then you will save a lot of maintenance costs.
First, motor malfunction:
The whole maize milling machine has more than ten sets of motors. Motor malfunction cannot be ignored. Too high temperature is one of the main reason of motor damage. All of the following factors may cause too high temperature: fuel starvation of the bearing, dirt mixing in the bearing, bearing damage or motor overload.
Second, spiral agitator malfunction:
1) The axle of the agitator does not turn caused by too much feeding or the driving belt slipping.
2) There has no grain discharging at the discharging port caused by the wrong motor diversion, port blocking or mixing arm breakage.
Third, air lock valve malfunction:
The common reasons that cause air lock valve malfunction: the air leak at the joint part, impeller wear, and so on. If it is caused by the impeller wear, we can add a rubber board at the outer edge.
Fourth, we should install the separate power switch which is accordant with the rated power, with reliable ground lead. The single maize milling machine should install stable power supply according to the inst ruction book requirement.
Each maize milling machine should be well checked regularly to avoide unnecessary malfunctions. We should carefully maintain the flour milling machine to extend the use span.
see more details on www.flour-milling-machine.com
contact me through joannayan198712@gmail.com
First, motor malfunction:
The whole maize milling machine has more than ten sets of motors. Motor malfunction cannot be ignored. Too high temperature is one of the main reason of motor damage. All of the following factors may cause too high temperature: fuel starvation of the bearing, dirt mixing in the bearing, bearing damage or motor overload.
Second, spiral agitator malfunction:
1) The axle of the agitator does not turn caused by too much feeding or the driving belt slipping.
2) There has no grain discharging at the discharging port caused by the wrong motor diversion, port blocking or mixing arm breakage.
Third, air lock valve malfunction:
The common reasons that cause air lock valve malfunction: the air leak at the joint part, impeller wear, and so on. If it is caused by the impeller wear, we can add a rubber board at the outer edge.
Fourth, we should install the separate power switch which is accordant with the rated power, with reliable ground lead. The single maize milling machine should install stable power supply according to the inst ruction book requirement.
Each maize milling machine should be well checked regularly to avoide unnecessary malfunctions. We should carefully maintain the flour milling machine to extend the use span.
see more details on www.flour-milling-machine.com
contact me through joannayan198712@gmail.com